THE AQUA-TANK HOUSING S100

The precision made aluminium housing consists of the body tube, the front cap and the rear cap, which are both double o-ring sealed.
 (THE TEL-DISPLAY) and the receptacle are single o-ring sealed and the sightglass for the TEL- display is additonal sealed with a flat gasket.  To recharge the battery the front cap must be opened.

The AQUA-TANK S100 housing is available as PRO (PROFESSIONAL) version with aluminium hard coat surface finishing.  (THE PRO/HD VERSIONS).

All AQUA-TANK´s are either with DRY-CONNECTOR or with WET-CONNECTOR  available. To mount the AQUA-TANK on a bottle or to wear it on the body there are different attachments available.

THE POWER PACK FOR AQUA TANK S100

The power pack of the AQUA-TANK S100 consists of high efficiency Nicad or NiMh-cells, which are mounted betweeen two plastic shells (PA6.6). The front shell is containing the charging socket. The power pack is complete mounted on the rear cap. In the rear cap there is also the power connector and if provided, the magnetic on/off switch and the sightglass of the TEL-display.

To recharge the power pack the front cap must be opened. The cap must be unscrewed (cap without outlet) to open the AQUA-TANK and for recharge the power pack. As additional safety against overcharge AQUA-TANK´s have built-in  THE THERMAL-DETECTOR.

To switch ON/OFF the lamp all AQUA-TANK S100 are available with a rotating knob, which contains the magnet to, switch the reed sensor, which is mounted inside the cap. The AQUA-TANK S100 is available with different electronics as there are:
                    elektronic E/A or deep discharge protection TES or TESVG (THE ELECTRONIC CONTROL SYSTEM)

All AQUA-TANKS are available with or without electronic switch.

THE MAGNETIC ON/OFF SWITCH

THE ELECTRONIC CONTROL SYSTEM

THE MULTI-LED-DISPLAY

AQUA-TANK S100  fits and powers these light heads:

AQUA-TANK SPECIFICATION AQUA-TANK S100 PRICES