THE AQUA-BELT
The alternative under water power supply is the AQUA-BELT.
Two models are available: the model with one housing tube for the 12V type or
the model with two housing tubes for 24V-30V or the 16Ah types.
The AQUA-BELT is available with
Dry- or Wet Connector and ON/Off switch. The main body is a
molded rubber tube, which is closed on the one end by the connector housing and
on the other end by the switch housing, or by a blind cap, if the AQUA-BELT is
ordered without switch.
The housing will be carried in a softbelt around the waist.
THE POWER-PACK FOR AQUA-BELT
The power pack for the AQUA-BELT consists of selected high efficiency
heavy duty industry type Nicad cells or NiMh-cells. Each battery is mounted in a
plastic cap, connected to each other by silicon wire and contained in the rubber
tube.
As additional safety against overcharge the AQUA-BELT has built-in
THE THERMAL-DETECTOR.
To switch ON/OFF the lamp, the AQUA-BELT has a magnetic switch, which is
in the knurled switchknob. The sensor is in the aluminium switch housing. By
turning the red knob, which contains the magnet, the AQUA-BELT can be switched
on and off. The AQUA-BELT is only available with or without ON/OFF electronic.
THE ELECTRONIC CONTROL SYSTEM
AQUA-BELT fits and powers all this light light heads:
